How to make a claymore pt4

• step 4Base of Mine

Take the ABS Cap and locate the EXACT center of it. It is very important that you take the time to get this as close as possible. My method is to take a straight edge and strike a line through the middle of the cap. Rotate the cap about 45 degrees and repeat. Do this a few times and you will end up with a bunch of lines whose intersection is almost exactly the center of the cap. Drill a 3/32 hole through the center. Put the screw into the hole so that the tip of the screw penetrates the inside of the cap. Tighten the screw down, but be careful not to strip the cap. It’s also important to keep this screw as straight as possible